Orion-system VCM-X E-BUS Component Instrukcja Użytkownika Strona 39
- Strona / 128
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
VCM-X Component & Systems Wiring
VCM-X E-BUS Controller Wiring
39
FILENAME
DATE:
DESCRIPTION:
PAGE
JOB NAME
OVCMX-ZoneByp-SFVFD-Wr1A.CDR
1 of 1
01/09/13
VCM-X E-BUS Controller Wiring Detail
Supply Fan VFD or Bypass Damper Actuator
+
Supply Fan Variable Frequency Drive
(By Others)
_
0-10VDC Input From AO2
Shield
GND
Caution:
The VFD Unit Must Be Configured For 0-10 VDC Input.
The Input Resistance At The VFD Must Not Be Less
Than 1000 Ohms When Measured At The VFD
Terminals With All Input Wires Removed.
Note:
Wire To The VFD Using 18 GA Minimum 2
Conductor Twisted Pair With Shield Cable.
Wire Shield To GND As Shown
AO2
GND
Shield
VCM-X E-BUS Controller
AI1
AI1 SET AI2 SET AI3 SET
AI4 SET AI5 SET AI7 SET
AI2
AI3
AI4
AI5
AI7
Bypass Damper Actuator
(Belimo Actuator Shown)
0-10 VDC
24 VAC Power Source
Sized For Actuator VA Load
GND
24 VAC
3 (Y)
5 (U)
2 (+)
1 (-)
Belimo Actuator Wiring
Shown. Consult Factory For
Other Manufacturer Wiring
Instructions
VCM-X E-BUS Controller
GND
AO2
AI1
AI1 SET AI2 SET AI3 SET
AI4 SET AI5 SET AI7 SET
AI2
AI3
AI4
AI5
AI7
Note:
Either The Supply Fan VFD Or
The Bypass Damper Actuator
May Be Connected To AO2 On
The VCM-X E-BUS Controller.
Only One Option Is Allowed,
Not Both.
Note:
Either The Supply Fan VFD Or
The Bypass Damper Actuator
May Be Connected To AO2 On
The VCM-X E-BUS Controller.
Only One Option Is Allowed,
Not Both.
S. Olson
Supply Fan VFD & Bypass Damper Actuator
Figure 22: Supply Fan VFD & Bypass Damper Actuator Wiring
- VCM-X E-BUS Component & 1
- Table of Contents 2
- Commissioning 5
- Systems Overview 6
- System Types 6
- Wiring Considerations 8
- Wire & Transformer Sizing 9
- Orion VCM-X System 9
- WARNING! 10
- Stand-Alone 11
- System Installation 12
- Networked Single Loop 13
- Networked Multiple Loop 17
- System Commissioning 20
- Overview 20
- System Configurations 21
- Typical Stand Alone System 22
- Interconnected System 23
- Networked Single Loop System 24
- Note: CommLink Must Be Set 29
- For Multiple Loop Operation 29
- Connect To Modular 30
- I/O Connectors 30
- Located On Back 30
- Of The System Manager 30
- VCM-X E-BUS 31
- VCM-X E-BUS Controller Wiring 32
- Main Controller Wiring 32
- Main Controller Addressing 33
- Sensor Wiring 34
- Duct-Mounted CO 35
- VCM-X E-BUS Controller 37
- Caution: 39
- VCM-X Expansion 41
- Expansion Module Wiring 41
- VCM-X Expansion Module Wiring 42
- Input Wiring 42
- Output Wiring 43
- VCM-X Expansion Module 46
- OVCMX-BinInput-4BIN-1A.CDR 47
- OA Humidity Sensor 48
- Space Humidity Sensor 49
- RA Humidity Sensor 50
- OVCMX-BldgPr-Wr-1A.CDR 52
- Building Pressure Control 52
- Damper Actuator 52
- Modular Cable 53
- Connect To VCM-X Controller 53
- Connect To Next Expansion 53
- Board (When Used) 53
- Modulating Cooling Device 54
- (Configurable) 54
- Expansion 55
- OVCMX-12RelayWire-1A.CDR 56
- GTC116 Series, GreenTrol 57
- MicroTrans 57
- Modular & Non-Modular 59
- VAV/Zone Controller 59
- Diagrams 59
- OE210-02, OE211-02, OE212-02 60
- OE217-00 / OE217-01 60
- Digital Room Sensor 60
- Slaved Zone Wiring 68
- Communication Devices 69
- OE392-12 Modular System 71
- Manager SD 71
- Back of Front Cover 71
- OE392-10 75
- System Manager TS II 75
- Back View 75
- IP-ModInstall1A.CDR 77
- CommLink 5 79
- Communication Loop Wiring 81
- CAUTION! 83
- Add-On Devices Diagrams 85
- Add-On Devices 86
- GPC-X Controller Wiring 87
- GPC-XP Controller Wiring 89
- GPC-XP CommLink Setting 91
- OE332-23-GPC-XP 91
- GBD-X Controller - CO 92
- Applications Wiring 92
- Applications Wiring (Cont’d) 93
- Module Wiring 97
- & Connections 97
- OE370-23-HP1C 98
- One Condenser 98
- Head Pressure Module 98
- OE370-23-HP2C2 99
- Two Condenser 99
- Head Pressure II Module 99
- OE370-23-FD-A 100
- Full Digital Module 100
- OE370-23-DD-C 101
- Dual Digital Module 101
- Controller Wiring 102
- AAON MODGAS-X Wiring 103
- (OE377-26-00060) 104
- MODGAS-XWR CONTROLLER 104
- MHGRV-X CONTROLLER 107
- (OE377-26-00059) 107
- OE334-26-WSHP-X2 108
- Water Source 108
- Heat Pump X2 Module 108
- AAON PREHEAT-X Wiring 110
- AAON MODGAS II Wiring 111
- AAON MHGRV II Controller 112
- Only Required When More Than 113
- Valves Are Needed 113
- MHGRV III Controller 113
- Miscellaneous Diagrams 115
- & Technical Information 115
- Modular Room Sensor Wiring 116
- EPROM Chip Locations 117
- EPROM Chip Locations (Cont’d) 118
- SD Memory Card Update 121
- E-BUS Modules 122
- OE275-01 Suction Pressure 126
- Refrigerant 126
Powiązane produkty i podręczniki dla Sprzęt komputerowy Orion-system VCM-X E-BUS Component
Sprzęt komputerowy Orion-system One Condenser Head Pressure Module Instrukcja Użytkownika
(24 strony)
(24 strony)
Sprzęt komputerowy Orion-system Two Condenser Head Pressure II Module Instrukcja Użytkownika
(16 strony)
(16 strony)
Sprzęt komputerowy Orion-system Dual Electronic Expansion Valve Module Instrukcja Użytkownika
(24 strony)
(24 strony)
Sprzęt komputerowy Orion-system Two Condenser Head Pressure Module Instrukcja Użytkownika
(24 strony)
(24 strony)
© 2020, manymanuals.pl. Wszelkie prawa zastrzeżone. | 0.067 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji