Orion-system VCM-X/RNE Operator Interfaces Instrukcja Użytkownika Pobierz pdf (Strona 8)

INTERFACES OVERVIEW

VCM-X / RNE Operator Interfaces Technical Guide

Service Tool and System Manager Keys

Operator Interfaces Comparison

In order to conﬁ gure and program the Orion System controllers, you must

have an Operator’s Interface or a personal computer with the Prism II

computer front-end software installed. Three different Operator Inter-

faces are available for programming of the Orion Controls System—the

Modular Service Tool, the Modular System Manager (VCM-X and VAV/

Zone Controllers only), and/or the System Manager TS II. These devices

allow you to access the status and setpoints of the controllers on your

communications loop. This manual describes the Modular Service Tool

and Modular System Manager. If using the System Manager TS II, please

see the System Manager TS II Technical Guide.

Mode

Selection

ENTER

CLEAR

ESC

DOWN

DEC

MINUS

STATUS

SETPOINTS

SCHEDULES

CONFIGURATION

ALARMS

OVERRIDES

BALANCE - TEST

ENTER

CLEAR

ESC

DOWN

DEC

MINUS

STATUS

SETPOINTS

SCHEDULES

ALARMS

OVERRIDES

System Manager

Modular Service Tool

Modular System Manager

The Modular Service Tool and System Manager allow you to view any

temperature or output condition and change any setpoint to ﬁ ne-tune

the operations of the total system. All keypad operations are simple and

straightforward, utilizing non-cryptic plain English messages.

Display Screens & Data Entry Keys

The System Manager’s and Modular Service Tool’s display screens are

very similar. For most setpoints and modes, there are only a few dif-

ference in the function of the keypads. In this manual, when there are

differences in the keypad input or the screens between the two operator’s

interfaces, both screens or keypads will be shown. See the chart below

for a list of the keypad descriptions and functions.

Keypad

Description

Key Function

System Manager Modular Service Tool

ESC

Use this key to exit from

screens or from data entry

or to return to the Main

Menu from any screen in

the system.

Same function as

System Manager

ENTER

Use this key to close

a data entry ﬁ eld and

advance to the next item

or screen.

Same function as

System Manager

Clear

If a data entry mistake is

made, press this key to

clear the data entry ﬁ eld

and start over.

Same function as System

Manager but also turns

off the power to the

Service Tool when on the

Main Menu Screen

Minus

If a setpoint with a

negative value is required,

press this key for the

minus sign.

Same function as

System Manager

DEC

Press this key when

entering data that requires

a decimal point.

Same function as

System Manager



Use these keys to step to

the next controller on the

loop on interconnected or

networked systems.

Same function as

System Manager





Use these keys to step

backward or forward

through the screens.

Same function as

System Manager

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 83 84

Komentarze do niniejszej Instrukcji

Brak uwag

Orion-system VCM-X/RNE Operator Interfaces Instrukcja Użytkownika Strona 8

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Orion-system VCM-X/RNE Operator Interfaces